Note: Only drivers that are not included or embedded within a supported operating system are listed below. To see a complete list of supported operating systems see the Product Specifications
Number of RAID Controllers
One or two
Host/Device Data Burst Rate
One or two Gbit full duplex
Number of Host Channels
One or Two
Number of Device Channels
Bus Configurations
Dual independent FC loops
Backplane design
Passive single backplane
Error Notification
Enclosure services via in-band SES, LEDs, audible alarms, FRU revision and serial number reporting, events reported to Storage Director
Number of Drive Bays
14
Drive Types
3.5" form factor, 1.0" height
Drive Capacity
300GB 10K rpm FC 146GB 10K rpm FC 73GB 10K rpm FC 146GB 15K rpm FC 73GB 15K rpm FC 36GB 15K rpm FC
Maximum Capacity per Enclosure
3.6TB
Advanced RAID Features
Dual active with automatic, transparent failover/failback Auto-negotiate speeds In-band and out-of-band management Replacement controller reflashes firmware to match peer controller Selective LUN deletion LUN Masking - up to 32 LUNs and 256 host ports supported F_port and FL_port support Cache coherency Battery protected mirrored write cache Write through, write back or read-ahead cache support per logical device Variable cache line size Controller-to-controller communications across back-end loops Disk scrubbing and soft disk addressing
Input Voltage
85 264 VAC (autoranging)
Input Current
100-240 VAC @10-5 A
Input Frequency
47-63Hz
Dimensions
H- 5.22 inches, W- 17.5 inches, D- 20 inches
Weight
60Lbs (with drives)
Complimentary support and/or full manufacturer warranty are provided as well as online resources.
See all Knowledgebase articles SANbloc 2Gb RAID View articles